How to install a new filter?

Remove the filter from its packaging and soak the filter in water for 10 minutes before first use. Install the filter into the reservoir and put the filter lid on. The lid should snap into place. Fill up the reservoir with tap water. Pour out the first batch.*

When switching to a new filter, you will need to reset the filter tracking on the wand. To reset filter tracking, you can do so in the LARQ App or manually by holding down the λ button for 5 seconds (the indicator light will turn white for 5 seconds followed by a flash of blue light).

*Note: you may notice some black carbon dust in the water on your first use or after a prolonged period of not using the LARQ Pitcher PureVis™. This is harmless carbon from our plant-based filter media. If desired, simply run a batch through the filter and pour it out.